Changes
/* Wiring */
The simplest method of drawing wires is to click and hold on a pin with the selection arrow cursor and then drag a wire from it. A wire will follow. Let it go and the wire will stay in the circuit. This would save you from having to switch back and forth between the wire tool and selection tool. If there already is a wire from a pin, you can drag more of the wire from the pin using the same method.
[[File:b2MAN_Fig35.png|thumb|centerleft|700px720px| Step-by-step wiring between two nodes by simply pulling a wire from the origin pin in normal Select Mode and dragging and dropping it at the destination node.]]
Wires can be automatically drawn and broken (redirected) at 90 degree angles. This feature can be turned on either from the Edit > Schematic Options menu or from the [[Schematic toolbar|Schematic Toolbar]]. In this case, wires will be drawn at the nearest 90 degrees to where the previous wire was segment ended. Wires can also be set to snap to the grid by choosing the respective option either in the Edit > Schematic Options menu or from the [[Schematic toolbar|Schematic Toolbar]].
