Changes

In AC sweep [[tests]] and other AC-types [[tests]] such as network analysis, the simulation output data are complex-valued. In this case, you have to specify whether you want to plot the magnitude or phase of a signal or its real or imaginary parts. In the case of magnitude, you have to specify whether to use dB or linear scale. In the case of phase, you have to specify whether to use degree or radian units. All of these can be done from the "Complex Signal Settings" section of the Edit Plot List dialog. This section is enabled only for [[tests]] of AC types. Alternatively, you can place special voltage or current probes with "dB", "Mag " or Phase"Ph-Deg deg" designations as shown in the Probe Menu on the right. The figure below shows a graph showing the magnitude of the input and output voltages of the previous Op-Amp circuit at the end of an AC sweep simulation.

[[File:b2MAN_Fig115.png|thumb|600px|A Cartesian graph showing the magnitude of input and output voltages of the Op-Amp circuit.]]