If your circuit contained XSpice parts, you will have to designate whether the pin is digital or analog. If the pin is Digital, then you must also designate whether it is an Input or Output pin. If the pin is Analog, then input and output direction designation do not apply. Click accept when you're done with each pin. Click OK when you're done setting the pins.
For Digital parts, Select and edit the [[Digital Simulation|digital simulation]] model you just created. In the Edit Simulation Model dialog box, click the Edit Pin Properties button to access the list of digital pin. You should set each pin's direction, state, and propagation delay. Click the Accept button to accept changes and move on to the next pin. Refer to the Database Editor Menu's Edit simulation model section for more information.
Once you're done setting the pin properties, close all the dialog boxes. All that remains is to alter the symbol if you want to rearrange the symbol pins and exit the Database Editor. In the Workshop pull up your new part and use it like any other part.