This example illustrates lofting from the edge of the lower box to a corner point on the center rectangle.
[[File:cad_manual-63_tn.png|600px540px|Loft Example 1]]
Example 2: Using Lofts To Create A Four-Sided Pyramid
<table>
<tr>
<td> [[Image:scale3_tn_new.png|thumb|720px600px|Constrained scaling of a box along an edge.]] </td>
</tr>
<tr>
<td> [[Image:scale4_tn_new.png|thumb|720px600px|Constrained scaling of a box normal to an edge.]] </td>
</tr>
</table>
<table>
<tr>
<td> [[Image:consttranslate1_tn_new.png|thumb|600px540px|Translating a box from a face snap point while holding the Alt Key down.]] </td>
</tr>
<tr>
<td> [[Image:consttranslate2_tn_new.png|thumb|600px540px|Translating a box from an edge snap point while holding the shift Key down.]] </td>
</tr>
<tr>
<td> [[Image:consttranslate3_tn_new.png|thumb|600px540px|Translating a box from a vertex snap point while holding the shift Key down.]] </td>
</tr>
</table>