Changes

To run a PO sweep, open the '''Simulation ''''''Run Dialog''' and select one of the above sweep types from the '''Simulation Mode''' dropdown list of this dialog. If you select either frequency or angular sweep, the '''Settings''' button located next to the simulation mode dropdown list becomes enabled. If you click this button, the Frequency Settings Dialog or Angle Settings Dialog opens up, respectively. In the frequency settings dialog, you can set the start and end frequencies as well as the number of frequency samples. The start and end frequency values are initially set based on the project's center frequency and bandwidth. During a frequency sweep, as the project's frequency changes, so does the wavelength. As a result, the mesh of the structure also changes at each frequency sample. The frequency settings dialog gives you three choices regarding the mesh of the project structure during a frequency sweep: