|-
! scope="row"| In2
| Digital Input
| 1-bit
|-
! scope="row"| In3
| Digital Input
| 1-bit
| 1-bit
|-
! scope="row"| A1- A2
| Generic NAND Gate
| Defaults
|-
! scope="row"| A2A3
| Generic Inverter Gate
| Defaults
</table>
Your circuit project workspace at this point should like the figure below:
<table>
</table>
Finally, use one the wiring methods you learned in the earlier analog tutorial lessons to connect all the parts and I/O ports. At the end, you should have a digital circuit similar to the figure shown at the beginning of this lessonbelow. Straight wires can always be drawn by simply clicking on device pins and dragging a line out of the pins. For drawing bent lines and multi-segment lines, sometimes you have to use the '''Wire Tool'''.
<table>