The [[MoM3D Module]]'s run simulation dialog with frequency sweep selected and the frequency settings dialog.
Â
You can run an angular sweep only if your project has a plane wave excitation. In this case, you have to define a plane wave source with the default settings. During an angular sweep, either the incident theta angle or incident phi angle is varied within the specified range. The other angle remains fixed at the value that is specified in the '''Plane Wave Dialog'''. You have to select either '''Theta''' or '''Phi''' as the '''Sweep Angle''' in the Angle Settings Dialog. Then you can set the start and end angles as well as the number of angle samples.
Â
[[File:wire_pic23.png]] [[File:po_phys54.png]]
Â
The [[PO Module]]'s run simulation dialog with angular sweep selected and the angle settings dialog.
In a parametric sweep, one or more user defined [[variables]] are varied at the same time over their specified ranges. This creates a parametric space with the total number of samples equal to the product of the number of samples for each variable. The user defined [[variables]] are defined using [[EM.Cube|EM.CUBE]]'s '''[[Variables]] Dialog'''. For a description of [[EM.Cube|EM.CUBE]] [[variables]], please refer to the [[CubeCAD|CUBECAD]] manual or the "Parametric Sweep" sections of the FDTD or [[Planar Module]] manuals.