Changes

Note that it is your responsibility to set up coupled ports and coupled transmission lines properly. '''For example, to excite the desirable odd mode of a coplanar waveguide (CPW), you need to create two rectangular slots parallel to and aligned with each other and place two gap sources on them with the same offsets and opposite polarities.''' To excite the even mode of the CPW, you use the same polarity for the two collocated gap sources. Whether you define a coupled port for the CPW or not, the right definition of sources will excite the proper mode. The couple ports are needed only for correct calculation of the port characteristics.

Figure 1: Coupling gap sources in the Port Definition dialog by associating more than one source with a single port.